Roland 24 bit Digital Studio Workstation VS-890 - Manual (Page 105)

Add Finishing Touches to Your Song
Press PARAMETER [ ► ► ]. "MasStatus=" appears in the
display.
fi
Rotate the TIME/VALUE dial to select "Rec."
MasStatus fmasterina track status)
Specify the status of the mastering tracks.
Rec: Playback tracks 1-6 while recording them to the mastering tracks
(7 and 8).
Play: Playback the mastering tracks (7 and 8). The sound of tracks 1-6 will
not be output from the MASTER jacks.
When the mastering room
is on,
MasStatus (status)
can be switched by
pressing
STATUS [7]
or
[ 8 ].
As necessary, use PARAMETER [ ◄ ◄ ] or [ ►► ] and the
TIME/VALUE dial to make the following settings.
V-Track
Select the two V-tracks (L and R) that will be assigned as mastering tracks.
When a new song is created, V-track 8 of tracks 7 and 8 (7-8, 8-8) will be
assigned as the mastering tracks.
After Rec (after recording)
Specify the time location of the mastering track to which the mixdown will
be recorded. When creating an original audio CD, it is usually best to select
"ZERO."
ZERO:Place the data starting at OOhOOmOOsOOf
L:0S: Place the data after the end of the last phrase in the mastering tracks.
L:2S: Place the data two seconds after the end of the last phrase in the
mcistering tracks.
L:4S: Place the data four seconds after the end of the last phrase in the
mastering tracks.
Stay: Place the data at the time location at which it was actually recorded.
AutoMarker
If this is turned "On," a track number marker will automatically be assigned
to the beginning of the phrase that is mixed down. Normally you will set
this "On."
Depending on the After
Rec (after recording) setting
or on the location relative
to other markers, the
display may indicate
"Can't Set Marker, " and
the track number marker
may not be assigned.
me