Recording on a track, Making a multi-track recording, Play (display) – Roland 24 bit Digital Studio Workstation VS-890 User Manual
Page 31: Status, Clear
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Making a Multi-Track Recording
4
5
6
Move all channel faders to the 0 dB position.
Gradually raise the master fader to adjust the volume.
Adjust the input sensitivity, with the INPUT knob of the
channel input assigned as the source.
Get a strong input signal by having instrument volumes as
high as possible. At this time, raise the volume level as much
as possible without making the PEAK indicator light up.
Normally,
this range is adjusted that the level meter
moves within -12 to 0 dB when the channel fader is set to
OdB.
Recording On a Track
1
1
2
Press
[PLAY (DISPLAY)].
Hold down
[STATUS]
(any track is OK) and press
[CLEAR].
Use the input mixer
channel fader
to adjust the
volume level of each input
channel that you wish to
send to the master out. If
you have assigned these
input channels to tracks,
use chamiel fader to adjust
the recording level to each
tracks.
This
section
explains
the
procedure
for
the
INPUTl
jack
to
record
an
electric
guitar performance to track 1.
This will clear any existing
input
and/or
track
routing
assignments.