Roland 24 bit Digital Studio Workstation VS-890 - Manual (Page 6)

Preparations
In some countries, VS-890's do not come with the Hard Disk installed.
The Roland HDP88 series hard disk (sold separately in some countries) can
be installed in the VS-890. In order to take full advantage of the VS-890's
functionality for the number of tracks that can be recorded/playback
simultaneously, we recommend that you install an 2100 MB or higher
model.
Turn off the power of the VS-890 and of all connected devices,
and disconnect all cables from the VS-890.
Remove only the screws specified in the following diagram,
emd detach the front panel cover of the VS-890.
f
y''
-
■'
With the warning label of the hard disk facing upward, slide it
gently into the installation bay as far as it will go. You can
hook the indentation of the attachment hardware over the
protrusion on the chassis of the VS-890.
When the hard disk has been pressed all the way in, use the
screws that you removed to fasten the hard disk in place.
To avoid malfurictions, you
should remove the internal
hard disk before
transporting the VS-890. To
remove the hard disk,
reverse the procedure
described in
“installing an
Internal Hard Disk
(HDP88 series)
(p. 5)". In
particular when you ship
the unit or when you move
house, be sure to remove
the hard disk from the
VS-890, place the hard disk
in iis packing carton, and
put it in its special place
inside the VS-890 packing
carton.
Fold down the handle on the front of the hard disk, and
reattach the front panel cover as it originally was. This
completes installation of the hard disk.