Flintec FT-10xx - Manual (Page 9)

FT-10 Smart Process Indicator, Technical Manual, Rev. 1.0, January 2014
Environment and Enclosure
Operation temperature -10 °C to +40 °C; 85% RH max, non-condensing
Enclosure Panel type, front and rear panel are stainless steel; Aluminum body
Protection Front panel IP65
FT-10 AN Analogue
Communication
Voltage output 0-5 VDC, 0-10 VDC
Current output 4-20mA, 0-20mA
D/A Converter 16 bit
Max. cable length 300 meter
Max. load resistance
(current output )
500 Ω
FT-10 MB Modbus-RTU
Communication
RS-485 1200 to 115200 baudrate, 8N1 / 7E1 / 7O1
Response speed Up to 4 ms response delay after read/write commands
Max Stations Up to 31 stations per segment
FT-10 PB Profibus DPV1
Communication
Data rate Up to 12000 kbit/s with automatic baud rate detection
GSD file Generic GSD-file provided
Topology
Depending on physical media
RS-485: segmented line topology without stubs
Installations
Shielded twisted pair cable
Line length depending on physical media and transmission speed
Max. Stations Up to 32 stations per segment, up to 126 stations per network
Isolation Galvonically isolated bus electronics
Response speed Up to 4 ms response delay after read/write commands
FT-10 PN Profinet
Communication
Data rate 100 Mbit/s, full duplex
GSDML file Generic GSDML-file provided
TCP/IP settings
DHCP or manual IP assign over EtherX PC Software.
Device identity customization
Topology Line, Bus, Star or Tree topology depending on physical media
Installation
Switched Ethernet transmission with shielded twisted pair cables and RJ-45
connectors.
Web client Available
Isolation Galvonically isolated bus electronics
Response speed Up to 4 ms response delay after read/write commands