Flintec FT-10xx - Manual (Page 60)

FT-10 Smart Process Indicator, Technical Manual, Rev. 1.0, January 2014
10.1 Profinet Parameters
There are 7 parameters for Profinet network and Profinet set up is done by EtherX PC software over Local
Network Area as described in this section. EtherX PC software is available in CD which is supplied together
with the instrument.
Note: Station name is ‘pn-io’ as a default.
DHCP
Dynamic Host Configuration Protocol automates network parameters if it is enabled.
Default is ‘Disable’.
IP Address
If DHCP is disabled, obtain IP address manually.
Default is ‘192.168.16.250’.
Subnet Mask
If DHCP is disabled, obtain subnet mask manually.
Default is ‘255.255.255.0’.
Default Gateway
If DHCP is disabled, obtain default gateway manually.
Default is ‘192.168.16.253’.
Primary DNS
If DHCP is disabled, obtain primary DNS manually.
Default is ‘208.67.222.222’.
Secondary DNS
If DHCP is disabled, obtain secondary DNS manually.
Default is ‘208.67.220.220’.
Host Name
Enter a unique host name to the instrument.
Default is ‘ ’.