EVCO EPV4CBR Hardware manual - Manual (Page 27)

EVCO S.p.A. Vcolor | Hardware manual ver. 1.0 | Code 144VCOE104
page 27 of 38
Beep Mode 0 2 - - - 2
kind of beep when pressing a sensitive area of the display of the
device
0 = no beep
1 = always
2 = on condition the area is sensitive
Print Frame 0 1 - - - 0
showing frames instead small size pages
1 = yes
7.7.4 Configuration parameters of the submenu “CAN bus” of the menu “Networks”
The following table shows the meaning of the configuration parameters of the section “CAN Network” of the submenu “CAN bus” of the
menu “Networks”.
PARAM. MIN. MAX. U.M. DEF. DESCRIPTION
MyNode 1 127 - - - 99 local CAN node address, or of the device
Master - - - - - - - - - YES the device always works as master
Baud - - - - - - - - - Auto
baud rate of the CAN communication
20K = 20,000 baud
50K = 50,000 baud
125K = 125,000 baud
500K = 500,000 baud
Auto = the device automatically detects the baud rate of
the other elements of the networ, on condition
that it is one of those listed here above; on
afterwards set the baud rate to the same value of
the other elements
Timeout 1 240 s 5
time-out of the remote CAN communication, or with the other
elements of the network (once the time you have set with this
parameter has elapsed without CAN communication with an
element, this is disabled)
Network
Node
[1] 1 [32] 127 - - - - - -
remote CAN nodes address, or of the other elements of the
network (example for [1] 2)
[1] = node
2 = node address