EVCO EPV4CBR Hardware manual User Manual
Page 24
EVCO S.p.A.
Vcolor | Hardware manual ver. 1.0 | Code 144VCOE104
page 24 of 38
7.6
Configuring an element of a
CAN network with CANBUS
communication protocol
To configure an element of a CAN network with CANBUS
communication protocol, operate as follows:
1.
Disconnect the power supply of the device and of
the other element of the network.
2.
Connect the device to the other element of the
network through the CAN communication port;
look at chapter 3 “WIRING DIAGRAM”.
3.
Connect the power supply of the device and of the
other element of the network.
4.
Set the configuration parameter Network Node
with the procedure shown in paragraph 7.4
“Setting the configuration parameters of the menu
“Networks””.
According to the factory settings the CAN address
of a controller is 1 (in this case it is necessary to
set parameter Network Node to [1] 1) and the
CAN address of an I/O expansion is 2 (in this case
it is necessary to set the parameter Network Node
to [2] 2).
5.
Press and release over and over again the area
“ESCAPE” as long as the display shows the menu
“Network Status(CAN)”.
6.
Press and release the area “DOWN” to select the
element of the network.
7.
Press and release the area “ENTER”: the display
will show the main menu of the element of the
network.
8.
Configure the element of the network with the
procedures shown in chapter 7
“CONFIGURATION”.
Switch off/on the power supply of the element of the
network after the configuration.
Showing the menu “Network Status(CAN)”