EVCO EPV4CBR Hardware manual - Manual (Page 18)

EVCO S.p.A. Vcolor | Hardware manual ver. 1.0 | Code 144VCOE104
page 18 of 38
7 CONFIGURATION
7.1 Setting the date and the time
According to the factory settings the date is shown in the
format dd mm yy and the time in the format 24 h.
Through the parameters Year format and Time AM/PM it is
possible to set respectively another year format and time
format.
To set the date and the time, operate as follows:
1. Switch on the device and show the sensitive
areas; look at paragraph 6.1 “Switching on/off the
device”.
2. Press and release the area “USER”: the display will
show the menu “Network Status (CAN)”.
3. Press and release the area “ENTER”: the display
will show the menu “V-COLOR PROG”.
4. Press and release the area “DOWN” to select the
date and the time.
5. Press and release the area “ENTER”.
6. Press and release the area “UP” or the area
“DOWN” to set the value of the field.
7. Press and release the area “LEFT” or the area
“RIGHT” (possible modifications will be saved) to
set the value of the following or previous field.
8. Repeat steps 6... 7.
To quit the procedure, operate as follows:
9. Press and release over and over again the area
“ESCAPE”.
Selecting the date and the time