EVCO EPV4CBR Hardware manual User Manual
Page 19
EVCO S.p.A.
Vcolor | Hardware manual ver. 1.0 | Code 144VCOE104
page 19 of 38
7.2
Setting the language for
showing (if foreseen) the
words of the application project
To set the language for showing (if foreseen) the words of the
application project, operate as follows:
1.
Switch on the device and show the sensitive
areas; look at paragraph 6.1 “Switching on/off the
device”.
2.
Press and release the area “USER”: the display will
show the menu “Network Status(CAN)”.
3.
Press and release the area “ENTER”: the display
will show the menu “V-COLOR PROG”.
4.
Press and release the area “DOWN” to select the
menu “Languages”.
If the device works in browser modality, the menu
“Languuages” will not be accessible.
5.
Press and release the area “ENTER”.
6.
Press and release “UP” or the area “DOWN” to set
the value of the field.
7.
Press and release the area “ENTER”: the device
will quit the procedure.
7.3
Setting the configuration
parameters of the menu
“Parameters”
To gain access to the procedure, operate as follows:
1.
Switch on the device and show the sensitive
areas; look at paragraph 6.1 “Switching on/off the
device”.
2.
Press and release the area “USER”: the display will
show the menu “Network Status(CAN)”.
3.
Press and release the area “ENTER”: the display
will show the menu “V-COLOR PROG”.
4.
Press and release the area “DOWN” to select the
menu “Parameters”.
5.
Press and release the area “ENTER”: the display
will show the window “Input Password”.
6.
Press and release again the area “ENTER”.
7.
Press and release the area “DOWN” to set “-19”.
8.
Press and release the area “ENTER”: the device
will show the menu “Parameters”.
To select a parameter, operate as follows:
9.
Press and release the area “UP” or the area
“DOWN”.
To set a parameter, operate as follows:
10.
Press and release the area “ENTER”.
11.
Press and release the area “UP” or the area
“DOWN” to set the value of the parameter.
12.
Press and release the area “ENTER”.
Selecting the menu “Languages”
Selecting the menu “Parameters”
Access to the menu “Parameters”