EVCO EPV4CBR Hardware manual User Manual
Page 20
EVCO S.p.A.
Vcolor | Hardware manual ver. 1.0 | Code 144VCOE104
page 20 of 38
To quit the procedure, operate as follows:
13.
Press and release over and over again the area
“ESCAPE”.
Switch off/on the power supply of the device after the
parameters setting.
7.4
Setting the configuration
parameters of the menu
“Networks”
To gain access to the procedure, operate as follows:
1.
Switch on the device and show the sensitive
areas; look at paragraph 6.1 “Switching on/off the
device”.
2.
Press and release the area “USER”: the display will
show the menu “Network Status(CAN)”.
3.
Press and release the area “ENTER”: the display
will show the menu “V-COLOR PROG”.
4.
Press and release the area “DOWN” to select the
menu “Networks”.
5.
Press and release the area “ENTER”: the display
will show the submenu of the menu “Networks”.
6.
Press and release the area “DOWN” to select the
submenu (for example to select the submenu
“UART”).
7.
Press and release the area “ENTER”: the display
will show the window “Input Password”.
8.
Press and release again the area “ENTER”.
9.
Press and release the area “DOWN” to set “-19”.
10.
Press and release the area “ENTER”: the device
will show the selected submenu.
To select a parameter, operate as follows:
11.
Press and release the area “UP” or the area
“DOWN”.
To set a parameter, operate as follows:
12.
Press and release the area “ENTER”.
13.
Press and release the area “UP” or the area
“DOWN” to set the value of the parameter.
14.
Press and release the area “ENTER”.
To quit the procedure, operate as follows:
15.
Press and release over and over again the area
“ESCAPE”.
Switch off/on the power supply of the device after the
parameters setting.
Selecting the menu “Networks”
Selecting the submenu “UART”
Access to the submenu of the menu “Networks”