EVCO EPV4CBR Hardware manual - Manual (Page 13)

EVCO S.p.A. Vcolor | Hardware manual ver. 1.0 | Code 144VCOE104
page 13 of 38
3.7 Additional information for wiring diagram
- do not operate on the terminal blocks with electrical or pneumatic screwers
- if the device has been moved from a cold location to a warm one, the humidity could condense on the inside; wait about an
hour before powering it
- test the working power supply voltage, working electrical frequency and working electrical power of the device; they must
correspond with the local power supply; look at chapter 10 “TECHNICAL DATA”.
- disconnect the local power supply before servicing the device
- connect the device to a RS-485 network with MODBUS communication protocol using a twisted pair
- connect the device to a CAN network with CANBUS communication protocol using a twisted pair
- connect the power cables the most possible away from the signal’s ones
- for repairs and information on the device please contact the EVCO’s sales network.