Comtrol NS-link Windows NT - Manual (Page 92)

Appendix A. Windows NT Configuration Overview 92
Adding or Reconfiguring a RAS Device
12. If you select TCP/IP, the following window displays. Make the appropriate
selections for your environment and press OK.
13. If you select IPX, the following window
displays. Make the appropriate selection
for your environment and press OK.
14. Select OK to exit the Network
Configuration window and return to the
Remote Access Setup window.
Note: Choices made during network
configuration will effect the entire
system.
15. If you want to duplicate the configuration
you just created on any other COM port
(modem), highlight the COM port number
and select Clone. Otherwise, repeat
Steps 7
through 14 for each COM port (modem) you want to set up.
16. After setting up all the COM ports, select the Continue button.
17. Select the Close button at the Network/Services tab to complete the RAS
installation.
18. Select Yes when asked to reboot the computer. Windows NT RAS installation is
complete.
19. If necessary, install the latest NT Service Pack or Packs from Microsoft.