Comtrol NS-link Windows NT - Manual (Page 87)

Appendix A. Windows NT Configuration Overview 87
Installing Modems
7. Select the COM port number.
8. Select Finish. The modem software is installed on the selected ports.
Depending on prior configuration, you may be asked to enter your country of
use, area code, the number you dial to get an outside line, and whether you
have tone or pulse dialing at this time.
9. If you need to configure modem
properties (maximum baud rate, data
bits, parity, and so on), select the
Properties button, make the needed
changes, then select OK to return to this
window.
Note: For help configuring modem
properties, see the Windows Help
System.
10. If you need to configure dialing
properties (country, area code, calling
card number, and so on), select the
Dialing Properties button, make the
needed changes, then select OK to
return to this window.
11. Select Close.