Comtrol NS-link Windows NT - Manual (Page 28)

28 Initial NS-Link Installation
Windows 2000: NS-Link Installation
17. Select the Main Setup tab, highlight the device you want to configure, and
select Properties.
Note: If this is the first device you are installing, the Device screen will load
over the Properties screen.
18. Select MAC and enter
the address on the
MAC address label (on
the device).
The MAC address
format is:
00 C0 4E xx xx xx.
A space must separate
each pair of digits.
If your site has other
Comtrol network
devices on the
network, their MAC
addresses will display
in the droplist after
initial installation.
19. Verify the Number of
Ports on the device.
20. Optionally, rename the
NS-Link default name.
21. Optionally, set a different KeepAlive Timeout Period
You can set the amount of time in seconds that this device waits until it closes
this connection and frees all the ports associated with it.