Comtrol NS-link Windows NT - Manual (Page 37)

Updating, Adding, or Removing NS-Link Devices 37
Updating, Adding, or Removing NS-Link
Devices
This section discusses how to
• Update existing installations
• Add additional NS-Link devices to an existing installation
• Remove or disable the NS-Link driver
Note: See the User Guide or Hardware Installation document for your product if
you want to swap one NS-Link device for another NS-Link device. See
Locating Hardware Installation Documentation on Page 6.
Updating an Existing Driver
Use the appropriate procedure for your operating system.
Windows NT NS-Link drivers for Windows NT should not be updated but first removed and
then installed. See the Removing an Existing Driver subsection for
Windows NT
on Page 44.
Windows XP Use the following procedure to update an existing NS-Link driver for the Windows
XP operating system.
1. If necessary, unzip the self-extracting files from the Comtrol media or ftp/web
site. See
Locating NS-Link Software on Page 6, if you need to locate the device
driver.
2. Right-click My Computer, select Manage, and highlight Device Manager, expand
the Multi-port serial adapters selection, right-click the device for which you
want to update the driver, and select Update Driver.
3. Select Install from a list or specific location (Advanced) and Next.