Comtrol NS-link Windows NT - Manual (Page 36)

36 Initial NS-Link Installation
Windows NT: NS-Link Installation
18. Select Close.
19. Close the Comtrol NS-Link program group.
20. Select Yes to restart the
computer.
21. After rebooting, you
can go to the
appropriate subsection
to complete any further
configuration that is
required for your site.
• To configure an IP address in the device, go to Programming the IP Address
on Page 47.
• To configure NS-Link in MAC mode to run efficiently, go to Disabling
DHCP Requests (MAC Mode) on Page 54.
• To configure COM port properties, go to . COM Port Configuration on Page
63.