Comtrol NS-link Windows NT - Manual (Page 90)

Appendix A. Windows NT Configuration Overview 90
Adding or Reconfiguring a RAS Device
3. Highlight Remote Access Service and select the Properties button.
4. To reconfigure an existing RAS port, highlight the port/device and select the
Configure button. Then go to
Step 7 .
5. To add a new RAS device—for
example, if you are configuring a
new modem—select the Add button.
The Add RAS Device window
displays:
6. Use the droplist to select the COM
port (modem) that you want to
configure and select the OK button.
Note: If no modems appear on this
list, you need to install a
modem, see
Installing Modems on Page 85.
The Remote Access Setup
window displays again.