Comtrol NS-link Windows NT User Manual
Page 49
Device Configuration
49
Programming the IP Address
6.
If NS-Link retrieves the values assigned by the System Administrator, this
means that the hardware has been previously configured and go to
.
Note: The default address for the DeviceMaster RTS is 192.168.250.250.
If NS-Link returns all zeros, go directly to
.
If NS-Link did not retrieve the correct values (not zeros), select the Clear
button.
a.
Select the Clear button.
b.
Select the Ok button to clear the IP programming in the device.
c.
Select the Ok button to the IP programming not complete until the device
is reset popup.
d.
Select the Reset button and wait until the device reloads.
e.
Repeat
Note: The Comtrol device cycles its LEDs.
This manual is related to the following products: