Brother INSTAFAX FAX2100M - Manual (Page 85)

lV-5. USING SPEED DIAL NUMBERS
INTERRUPT
STOP
6) Enter the name (which can have up to 15 characters) in the way
described in the section entitled Entering information using the
keys. Press the SET key when you have finished.
CURRENT : FAX
l.FAX 2.TE L 3.0FF
7) Press the 1 key for Fax^ the 2 key for Telephone, or the 3 key for
off. This selection is only used for the dial list. Selecting "off'' is
used for group keys (see page IV-4-3) or chain keys (see page IV-
6
-
1
).
or f-rn
CURRENT : FAX
PRESS SET KEY
8) Press the SET key to confirm your choice. The screen again
shows:
SPEED DIAL
SELECT NO. #
9) You can either continue and register another speed dialnumber,
or end registration by pressing the STOP key.
Sending speed dial
faxes
To send a fax to a destination whose number is stored under a speed
dial key simply follow the steps for sending a fax, either manually
or automatically, and instead of dialing the number with the keys
just press the SPD. Dl AL key followed by the appropriate two digit
speed dial code. The stored fax number is dialed automatically. To
begin transmission just press the START key.
Printing a list of speed To print out a directory listing of the names and numbers stored as
dial numbers speed dial numbers.
1) Press the FUNCTION key. Then press the 4 key.
I laWWif»:«
]
4.LISTS AND REPORTS
PRESS SET KEY
)
INTERRUPT 2) Press the SET key, then press the 3 key.
3.SPEED DIAL
PRESS START KEY
IV-5-2