Change the presser foot – Kenmore Sewing Machine User Manual
Page 17
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
• Accessory Storage Box
The lid of the accessory storagebox lifts
open toward you.
Sewing accessories are conveniently
located in the box.
* Free-Arm Sewing:
the
Removable Extension Table
To Remove the Extension Table
(for free-arm sewing)
1. Grip the table with your index
finger and thumb, as shown.
..Of-41 ' (
a
'
• r U41
w «№ IV#IL J J UJ
extension table win snap out
To Attach the Extension Table
(for flat-bed sewing)
1. Insert the tab and the pin into
their catches.
2. With your thumb and index
finger, gently snap in.
• Change the Presser Foot
Use the correct presser foot for
the stitch you wish to sew.
To change presser feet, raise
the presser bar to its highest
position by lifting the presser
foot leva-. .........
Loosen the pr^er foot №umb
screw, choose the proper foot,
insert from the bottom.
Tighten the screw using the
large screw driver to make
certain the foot is secure.
Choose the Needle and Thread
• To Change the Needle
NOTE: Raise the needle bar to its highest
position by turning the hand wheel
toward you.
1. Loosen the needle clamp screw by turning it
towatrf yrm
..... ,
__. _
2. Rembwthe needle by pulling it downward.
3. Insert the new needle Into the needle clamp
with the flat side away from you.
4. Push the needle up as far as it will go.
5. Tighten the needle clamp screw firmly with
the large screwdriver from the accessory
box.