AERCO Control System (ACS) - Manual (Page 63)

MC2: 04/23/13 Page 63 of 144
GF-131
AERCO Control System (ACS)
AERCO International, Inc. • 100 Oritani Dr. • Blauvelt, New York 10913 • Phone: 800-526-0288
Installation, Operation, and Maintenance Manual
OMM-0081_0D
other number will be ignored.
The front panel switch would have top priority so that if it is switched Off by the front panel
button, it cannot be switched On by the modbus command. But if it is switched On by the front
panel button, it can be switched On and Off by the modbus command. Reading the status
would show “1” for On, “2” for Modbus Off, and “0” for Front Panel Off.
3.14 ACS QUICK-START GUIDE MENU
NOTE
The “Quick Start” procedures in this section ( 3.14) assume that the user
fully understands the ACS menu structure and is able to navigate
through these menus to display and change menu options. Refer to
paragraph 3.3 for menus and menu processing procedures.
The following procedure assumes that you are programming a new ACS that has the “Factory
Default” settings currently stored in memory.
If you wish to restore a “Field-Programmed” ACS to the “Factory Default” values, go to the
CALIBRATION MENU and select the RESET DEFAULTS option. ALL SETTINGS, EXCEPT
TIME AND DATE, WILL RETURN TO THEIR FACTOR DEFAULTS.
This paragraph provides the instructions to quickly start up and operate the ACS in some of the
most commonly used modes. The ranges and default values of the Menu Options used in the
following instructions are summarized in Appendix A.