KEYENCE N-400 - Manual (Page 50)

Chapter 3 N-400 Setup Procedure
42
3
ID SETUP
The ID SETUP screen is used to register the ID numbers of the connected BL
series. When you register the ID numbers in multidrop link mode, polling automati-
cally starts when the N-400 starts up. To perform manual polling, skip the ID
SETUP.
➮ Auto polling: p. 61
➮ Manual polling: p. 62
RS-232C
The RS-232C screen is used to set the RS-232C communication parameters for
the N-400. Set these parameters so that they conform to those of the host com-
puter or PLC.
1. Setting “RTS/CTS” is disabled when “Use PLC” is selected.
➮ RTS/CTS: p. 66
Tips
Tips