Benelli ETHOS Shotgun User Manual

Page 55

3) Insert the tip of a screwdriver through the

hole provided in the rear of the stock. Push
the bottom of the comb upwards to release its
back edge, then lift it and remove it from the
stock (fig. 73).

4) To fit the new comb, position it so that the

two dowels on its underside line up with the
holes in the seat on the stock, then push the
comb firmly down until it clicks into place
(fig. 74).

WARNING:

the edges of the comb must mate

perfectly with the profile of the stock when cor-
rectly fitted.

5) Fit the comfort kit “2” and then the butt plate

to the stock (see fig. 57).

Adjusting the rear sight

(when fitted)

If the default calibration of the rear sight proves
unsuitable, you can adjust for windage and ele-
vation as required.

Before beginning any operation on your shotgun,
always make sure that chamber and magazine
have been completely emptied!
(Carefully read loading and unloading instruc-
tions).

Adjusting the rear sight for windage

As for lateral adjustment of the rear sight, proce-
ed as follows (fig. 75):

1) Using the supplied key and referring to the

graduated alignment notches, adjust the rear
sight position into the required direction
(move it to the right if you want the point of
impact to move right and move it to the left if
you want the point of impact to move left).

Adjusting the rear sight for elevation

As for rear sight elevation adjustment, proceed as
follows (fig. 76):

1) Using the supplied key and referring to the

relative graduated alignment notches, adjust
the rear sight position into the required direc-
tion (move it upwards if you want to raise the
point of impact, or move downwards if you
want the point of impact to be lower).