Panasonic CQ VAD9300U - Manual (Page 84)

Electrical Connections
84
мапЕЁишшз
Accessory used for wiring
No. Item Q'ty
Power Connector (for display unit) 1
Reverse Extension Cord (for rear view camera) 1
Clip Connector 1
Display Unit/Hide-away Unit
Connecting Cord
1
Ф Optical Fiber Cable 1
No. Item Q'ty
Power Connector (for hide-away unit) 1
Ground Lead 1
Radio Antenna Extension Cord 1
Center Speaker Lead 1
@) Center Speaker Extension Lead 1
ir Display Unit/Hide-away Unit Connecting Cord
j RGB Input Cord j
■ To the RGB Connector of the Panasonic
! car navigation system (available in future).!
I__________________________________ i
Display Unit
(Rear)
Digital Audio Output
Connector (optical)
® Optical Fiber Cable
J Video Control Lead
I To the Video Control Lead of the
j Panasonic car navigation system j
! (available in future).
!
L._________________________ J
Side Brake (Parking Brake) Connection
Lead
■=
Be sure to \wire the side brake (parking
brake) for safety and preventing accidents,
page 88)
Reverse Lead
When connecting the rear view camera,
use the reverse lead. (=> page 93)
Note: Use a Reverse Extension Cord @ if
needed.
VIDEOCOMTb
(Green/yellow stripe)
J
(Blue/yellow stripe)
REVERSE 1=
(Violet/white stripe)
Power Lead
To ACC power, +12 V DC.
(Resistor 220 fì)
acc __ h :(
(Red)
Battery Lead _ ^
To the car battery, continuous +12 V DC. ‘^=°S^=^ battery
Ground Lead
To a clean, bare metallic part of the car
chassis.
(Black)
CQ-VAD9300U
Power Connector
Caution: Do not
insert the power
connector into the
unit until the wiring
is completed.
V
(Black)
Speaker Lead e
(Black/green stripe)