Panasonic CQ VAD9300U - Manual (Page 82)

Installation Guide
(continued)
Cautions:
• Be sure to install the TV antenna on the inner side of
the rear window.
• Be sure to connect the power lead of the TV antenna
to ACC power DC 12 V.
• Keep the antenna away from the externa! amplifier
and the rear speaker cord as much as possible.
Preparations:
Remove the upholstery at the both sides of the rear
window to establish a ground.
Remove the upholstery.
Observe the following to enhance adherability.
• Wipe the inner surface of the rear window with a
wet and soft cloth along the heating wire. But do
not leave water droplets on the glass.
• When the outside-air temperature is less than 68
“F (20 °C), switch on the rear window defogger or
the car heater to warm the surface of the rear win­
dow for approx. 5 minutes.
o
Straighten the bent antenna element.
Confirm the adhering positions.
Shorter side
Longer
side
Affix the antenna temporarily with adhesive tape after
confirming the antenna position.
For a hatchback type:
Stick the grounding plate skillfully and hold the loose
antenna element with the Antenna Clamp @) so that
the element will not become caught in the hatchback
door. Adjust the cord length so that the cord does
not interfere with the movement of the hatchback
door, and secure the cord with Cord Clamp
Antenna cable identification
To TV antenna
connector on the
hide-away unit.
Power Lead
To ACC power,
+12VDC.
Ground Lead
To a clean, bare
metallic part of
the car chassis.
(Fuse 0.5 A)
ACC013==(^
(Red)
(Black)
82
CQ-VAD9300U