Set-up: sound settings – Panasonic CQ VAD9300U User Manual

Page 66

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

^ SET-UP: Sound Settings

(continued)

Change audio channels as shown below by pressing [DRC] (PRO LOGIC) (DOWN MIX) for more than 2 seconds.

Changing Dolby Digital/
dts Audio to 2-Channel
Stereo Playback
(Down mix)

Select down mix for easier listening

if audio is too low to be heard.

• Dolby Digital

□□IDOLBYJ

D I G I T A L

DVDi

VIDEO

EUHHGUNO

5.1-Channel

surround playback

(Number of channels: 1 to

5.1)

Down mix ^

2-channel stereo playback

D'OtUfJlMIXl

---------------(RS).

' ' ■ Ct<€

-------- (LS)-

l(S.W)

• When down mix is selected, center (C) and surround (RS) (LS) signals are

mixed with the signals of the two channels (stereo) of right front (R) and left

front (L) to be output. There will be no audio output from the center (C),
surround (RS), (LS) and subwoofer (SW), while the output audio from the
fronts (R) and (L) will be a little greater.

• If "FRONT" is set to "SMALL” in speaker setting (^ page 58) after selecting

down mix, there will also be audio output from the subwoofer (SW).

Changing 2-channel
Dolby Surround Audio to

4-Channel Surround

Playback (Pro Logic)

Effective for Dolby Surround DVD
playback

• Dolby Surround (Dolby Pro Logic)

nni DOLBY suFmourcil DVD>

PRO-LOGIC VIDEO

2-channel Dolby Surround audio

□D PRO

logic

Pro Logic

4-channel surround playback

• When Pro Logic (4-channel surround playback) is selected, 2-channel Dolby

Surround audio is output after conversion to a 4-channel output from the
center (C), front (R), (L) and surround (RS), (LS). (The same audio from
(RS)and (LS).)

Changing 2-channel
audio/analog audio to

4-channel surround

playback (Pro Logic)

Even 2-channel audio/analog audio
not recorded in Dolby Surround

audio can be switched to
4-channel surround playback.

LPCM/MP3

VIDE

cay

•

Dolby Digital/dts 2-channel

• Analog audio (VTR, CD changer)

2-channel audio/analog audio

QQ PRO LOGIC

Pro Logic

4-channel surround playback

audio (except for Dolby Digital/dts
2-channel).

• When Pro Logic (4-channel surround playback) is selected, 2-channel

audio/analog audio is output after conversion to a 4-channel output from
the center (C), front (R), (L) and surround (RS), (LS). (The same audio from

(RS) and(LS).)

Note: Pro Logic (4-channel surround playback) selection does not apply to

TV and radio.

Note: For each audio recording system (Dolby Digital/dts/Dolby Surround (Dolby Pro Logic)/LPCM), refer to the
Definition of Terms. page 104)

CQ-VAD9300U