Panasonic CQ VAD9300U - Manual (Page 11)

This system is designed so that you cannot see
the moving picture while you are driving.
• Park your car in a safe place with pulling the side brake (parking
brake) lever before watching the monitor.
• A rear monitor (option) displays moving picture while driving.
WARNING
ENJOY THE MUSIC
Note: Be sure to connect the side brake (parking brake) connection lead. (=> page 88)
Cautions:
• Picture might not be displayed, or it might take more time than usual to display picture in low temperature.
Also, movement of picture might become labored, or picture quality might deteriorate in low temperature,
[practicable temperature: 32 °F to 104 °F (0 °C to 40 °C)]
• Do not touch the LCD (liquid crystal display).
If you touch the LCD, your fingerprints are conspicuous because the surface of the LCD was specially
processed.
• In some cases, noise is generated. It depends on the position or direction of a mobile phone and a CB transiever,
etc. Change the position or direction of the mobile phone and a CB transiever, etc. or keep them away from the unit.
ID Code
Prior to operating this unit, it is a advisable to assign your 4-digit ID code for security. (Make sure to use four digits for ID
code.)
Once the ID code has been set, the unit cannot be operated if the main power supply is disconnected then re-connected. It
is electronically locked so that a thief could not use the stolen unit unless that person knows the code you have set.
The ID code operation must be performed only by the person to whom the unit belongs.
Generally, it is not necessary to enter the ID code each time when using the unit if it has never been disconnected from the
main power supply (car battery). For the ID code setting procedures, see pages 42-43.
Caution: Record your registered ID code and keep it in a secure location. If you forget it, you will be unable
to use the unit. If you cannot operate the unit because you forget the ID code, please consult your nearest Panasonic
Servicenter.
ID Code Input
Enter the ID code after turning on the power and activating the display.
Success
Tnii precuct wiP not
with ЭП v)veii
(3
iD
W A R N I N G
TO AVOID Risr; Of 5ERI0U4
iJJUPV 0P.POS$l&Lf
VHDlATiON OP LAVS.
NOT FOP ose WKEPÉ
VISIBLE rO DRIVE P
FOR ANY FWOSEOiHEP
IKANIMVIGATION OP MU
V’JH RE A.? VIEV САПЕРА.
Note: When you fail in entering the ID code, a screen on the right is displayed and
the unit beeps three times. Enter a correct ID code.
If you fail to enter the correct ID code three times consecutively, the power is turned
off. Turn on the power again and enter a correct ID code in this case.
Thr> product wiTl not operati
«ilh an lA'vaTtd !D
CQ-VAD9300U
11