Panasonic NN46240-501 - Manual (Page 71)

3 CLI overview
Nortel Secure Router 8000 Series
Configuration Guide - Basic Configuration
3.4 CLI error messages
If a user enters incorrect commands, the grammar check fails and the CLI reports error
messages to the user. If all of the commands are correct, the grammar check passes. Table 3-2
describes common error messages.
Table 3-2 Common CLI error messages
Error messages Cause of the error
Unrecognized command The command cannot be found.
The key word cannot be found.
Wrong parameter A parameter type error occurred.
The parameter value exceeds the boundary.
Incomplete command Incomplete command entered.
Too many parameters Too many parameters entered.
Ambiguous command Indefinite parameters entered.
3.5 Command history
The CLI automatically saves a command history for each user. This function is similar to the
DOS-Key. By default, the CLI saves a maximum of 10 commands for each user. Table 3-3
describes the command history operations. You can run the saved history command at any
time.
Table 3-3 Access the command history
Action Key or command Result
Display the
command
history.
display
history-command
Display the user’s command history.
Access the last
history
command.
Up cursor key
t or Ctrl+P
Display the last history command if an earlier
history command exists. Otherwise, the alarm
bell rings.
Access the
next history
command.
Down cursor key 1
or Ctrl+N
Display the next history command if a later
history command exists. Otherwise, the command
is cleared and the alarm bell rings.
ED NOTE
On the Windows 9X HyperTerminal, the cursor key | is invalid because the Windows 9 HyperTerminal
defines keys differently. In this case, you can replace the cursor key | with
Ctrl+P .
When you use the history command, note the following:
3-8 Nortel Networks Inc. Issue 5.3 (30 March 2009)