1 establishing the configuration task, Applicable environment, Preconfiguration tasks – Panasonic NN46240-501 User Manual
Page 214: Data preparation, Configuration procedures, 2 checking for a running patch on the rpu, 2 checking for a running patch on the rpu -3, 1 establishing the configuration task -4, 1 introduction, 2 checking the system for running patches
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Nortel Secure Router 8000 Series
Configuration Guide - Basic Configuration
12 Patch management
12.2 Checking the system for running patches
12.2.1 Establishing the configuration task
Applicable environment
The system permits you to run only one patch at a time. You must confirm that no patch is
running in the current system before you install a new patch. If a patch is currently running,
you must delete it before you install the new patch.
Preconfiguration tasks
Before you check the system for running patches, complete the following tasks:
•
Ensure that the router starts normally after it is powered on.
•
Ensure that you can log on to the router.
Data preparation
None.
Configuration procedures
No.
Procedure
Checking for a running patch on the RPU
12.2.2 Checking for a running patch on the RPU
Do as follows on the router you want to upgrade.
Step 1 Run:
display patch-information
This command checks the master RPU for running patches.
Step 2 Run:
display patch-information slave
This command checks the slave RPU for running patches.
—End
Before you install a patch on the RPU, you must check for running patches on the master and
slave RPUs. For example:
--------------------- Patch information-----------------------------
patch version
program version
temp patch number
NORTELMPU001
V3R2B12D040-GR
0
Issue 5.3 (30 March 2009)
Nortel Networks Inc.
12-3
1