Configuration procedures, 2 specifying the slave rpu, 3 restarting the router – Panasonic NN46240-501 User Manual
Page 195: 2 specifying the slave rpu -5, 3 restarting the router -5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Nortel Secure Router 8000 Series
Configuration Guide - Basic Configuration
10 Router maintenance
Configuration procedures
No.
Procedure
1
2
3
Performing the master/slave switchover
10.3.2 Specifying the slave RPU
CQ NOTE
Secure Routers 8002, 8004, and 8008 contain only one RPU, so they do not support this function.
Do as follows on the router to configure.
Step 1 Run:
system-view
The system view appears.
Step 2 Run:
slave default
s l o t - n u m b e r
This command specifies the default slot number of the slave RPU.
The slot number specified by this command is reserved for the slave RPU after each restart of
the router. The other slot number is for the master RPU.
Step 3 Run:
quit
The user view appears.
Step 4 Run:
save
This command saves the current configuration.
—End
10.3.3 Restarting the router
A
CAUTION
Before you restart the router, run the save command to save the current configuration file.
Perform the following steps on the router, as required.
• To restart the router immediately, run:
Issue 5.3 (30 March 2009)
Nortel Networks Inc.
10-5