4 configuring the basic acl, 5 configuring the basic ftp acl, 6 checking the configuration – Panasonic NN46240-501 User Manual
Page 144: 3 configuring the basic acl -7, 4 configuring the basic ftp acl -7, 8 checking the configuration -12
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Nortel Secure Router 8000 Series
Configuration Guide - Basic Configuration
8 FTP, TFTP, and Xmodem
ftp server enable
This command enables the FTP server.
—End
8.4.4 Configuring the basic ACL
Do as follows on the router that serves as the FTP server:
Step 1 Run:
system-view
The system view appears.
Step 2 Run:
acl
acl-number
The ACL view appears.
Step 3 Run:
rule [
rule-id
]
{
deny | permit }
[ source {
|
source-ip-address
{ source-wildcard
|
0 }
| any }
| time-range
time-name
| vpn-instance
vpn-instance-name
]
*
This command configures the ACL rule.
—End
CÛ NOTE
FTP supports only the basic ACL.
8.4.5 Configuring the basic FTP ACL
Do as follows on the router that serves as the FTP server:
Step 1 Run:
system-view
The system view appears.
Step 2 Run:
ftp acl
acl-number
This command configures the basic FTP ACL.
—End
8.4.6 Checking the Configuration
Run the following commands to check the preceding configuration.
Issue 5.3 (30 March 2009)
Nortel Networks Inc.
8-11