Panasonic NN46240-501 - Manual (Page 108)

5 User management
Nortel Secure Router 8000 Series
Configuration Guide - Basic Configuration
5.4.8 Checking the configuration
Run the following command to check the previous configuration.
Action Command
Check the attributes of the
local user.
display local-user [ domain domain-name | user-name
user-name ]
5.5 Configuration examples
A
CAUTION
After you complete the following two configuration examples, the current user VTY 0 cannot
run commands at levels higher than 2. Ensure that you can log on to the router through other
methods to delete the configuration.
This section provides the following examples:
• Example of logging on to the router through password
• Example of logging on to the router through AAA
5.5.1 Example of logging on to the router through password
authentication
Networking requirements
The COM port of the PC is connected with the console port. Set the priority of VTY0 to 2 and
authenticate the passwords of users. Users must enter the password
Nortel to successfully log
on.
After logon, if operations are not performed within 30 minutes, the user interface is
disconnected from the router.
Configuration roadmap
1. Enter the user interface.
2. Configure the priority of VTY0 as 2.
3. Configure simple authentication and the disconnect time.
Data preparation
To complete the configuration, you need the following data:
• password of the authentication mode
• connection time
5-18 Nortel Networks Inc. Issue 5.3 (30 March 2009)