1 debugging telnet terminal services, 2 debugging ssh terminal services, Deleting ssh users – Panasonic NN46240-501 User Manual
Page 180: 2 configuring telnet terminal services -6, 1 debugging telnet terminal services -13, 4 maintaining telnet and ssh
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Nortel Secure Router 8000 Series
Configuration Guide - Basic Configuration
9 Telnet and SSH
Action
Command
Check information about an SSH user.
display ssh user-information [
user-name
]
9.4 Maintaining Telnet and SSH
This section describes the following topics:
•
Debugging Telnet terminal services
•
Debugging SSH terminal services
9.4.1 Debugging Telnet terminal services
When a Telnet fault occurs, run the following debugging command in the user view to locate
the fault.
A
Debugging affects the performance of the system. After you debug Telnet terminal services,
run the undo debugging all command to disable debugging.
Action
Command
Enable Telnet debugging.
debugging telnet
9.4.2 Debugging SSH terminal services
This section describes the following topics:
•
•
Deleting SSH users
Delete SSH users by using the following commands in the system view.
Action
Command
Delete the specified SSH user.
undo ssh user
user-name
Delete all the SSH users.
undo ssh user
Issue 5.3 (30 March 2009)
Nortel Networks Inc.
9-13