1 console port configuration, Applicable environment, Applications – Panasonic NN46240-501 User Manual
Page 49: 2 telnet configuration, 1 console port configuration -2, 2 telnet configuration -2, 1 introduction
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
2 Configuration environment setup
Nortel Secure Router 8000 Series
Configuration Guide - Basic Configuration
2.1 Introduction
This section describes the following three methods for establishing the configuration
environment:
•
•
2.1.1 Console port configuration
Applicable environment
You can configure the router by local logon.
Applications
Use the console port to configure the router in the following situations:
•
The router is powered on for the first time.
•
The configuration environment cannot be established through Telnet or the AUX port.
2.1.2 Telnet configuration
Applicable environment
You can configure the router by local or remote logon.
Applications
Préconfigure the IP addresses of interfaces on the router, the user account, the logon
authentication, and the incoming and outgoing call restriction. Also, ensure that directly
connected or reachable routes exist between terminals and the router.
The destination router authenticates the user based on the configured parameters in three
modes:
•
Password authentication: the logon user must enter the correct password.
•
AAA local authentication: the logon user must enter the correct user name and password.
•
Non-authentication: the logon user is not required to enter the user name or password.
If the logon succeeds, a command line prompt such as
N o r t e i
appears on the Telnet client
interface. Enter the command to check the running status of the router or to configure the
router. Enter ? for help.
2-2
Nortel Networks Inc.
Issue 5.3 (30 March 2009)