Canon PIXMA MP560 - Manual (Page 936)

5. Use the same procedure to open the other ports (138TCP, 138UDP,
139TCP, and 139UDP).
6. Confirm that the port names are added on the Exceptions sheet, and click
OK.
Check 5: Change the workgroup name to "WORKGROUP" following the
procedure below.
1. Right-click Computer (or My Computer), select Properties, then click Change
settings.
In Windows XP, right-click My Computer, then select Properties.
2. Click the Computer Name tab, then click Change.
3. Change the workgroup name to "WORKGROUP", then click OK.
Check 6: Disconnect the network drive for the Card Slot and mount it
again following the procedure below.
1. Right-click Computer (or My Computer), and select Disconnect Network Drive.
2. Select the network drive to disconnect, then click OK.
3. Remount the Card Slot using the Canon IJ Network Tool.
Using the Card Slot over a Network
Page top
Page 936 of 949 pages Cannot Access to the Card Slot Because of Some Security Settings on the Co...