Rice Lake TransAct 5.0 - Installation & Operation Manual - Manual (Page 194)

183
Notice how the settings print out is listed in 3 columns. The first column designates the
Group. The second column designates the Item in the Group. The third column
designates the Setting of the Item. Use the buttons designated as Group, Item, and Set to
modify the printer settings.
Group
Cycles through the various groups in the menu (i.e. Font, Rear
Feed, Serial I/F, etc...)
Item
Cycles through a Group’s items (i.e. Emulation Mode, Form Tear
Off, Parity, Protocol, etc...)
Set Cycles through an Item’s Settings (i.e. 8 Bits, 7 Bits, etc...)
Print Prints the current Settings for all Items in all Groups
For example, to turn the Form Tear Off setting on for rear feed paper control, press the
Group button until Rear Feed appears in the first column. Press the Items button until
Form Tear Off appears in the Items column. Finally press the Set button until 500ns
appears. Exit the menu setup.
AWS Standard Settings for OKI ML320 with Serial Card
GROUPS ITEMS SETTINGS
Printer Control Emulation Mode IBM PPR
Rear Feed Form Tear-Off 500 ns
AWS Standard Settings for OKI ML320 with Serial Card
Serial I/F Parity None
Serial I/F Serial Data 7/8 Bits 8 Bits
Serial I/F Protocol XON/XOFF
Serial I/F Diagnostic Test No
Serial I/F Busy Line DTR
Serial I/F Baud Rate 9600 BPS
Serial I/F DSR Signal Invalid
Serial I/F DTR Signal Ready on Power UP
Serial I/F Busy Time 200 ms