Rice Lake TransAct 5.0 - Installation & Operation Manual - Manual (Page 101)

90
Reset Reset the data terminal
Unattended Put terminal in unattended mode
GetWeight Get a weight from the unattended terminal
GetWeight Get another weight
GetWeight Get another weight
GetWeight Get another weight
Attended Put terminal in attended mode
Enable Repeater (Single Command)
When this box is checked, the command entered in the Data to Send box will be sent
repeatedly to the ATS-2.
Timer Interval (msec)
Enter the time interval between commands for the Loop and Repeater options.
Units
This field is not used.
Data Received
This field contains the message received from the ATS-2 in response to a command.
Data to Send
Enter a command to send to the ATS-2.
Attended Place ATS-2 in attended mode
Unattended Place ATS-2 in unattended mode
DriveAhead Drive ahead command
DispMsgN Display message on line N. This command is
immediately followed by the message to display.
Error Error command
GetCode Wait for and return driver entry
GetWeight Get current weight
MoreMatrls Ask driver if there is another material for this ticket
OpenGate A valid truck id has been entered, open gate
PrintLine Print ticket line
PrintEnd Done printing ticket
Reset Reset ATS-2