Rice Lake 720i Programmable Indicator/Controller - Installation Manual - Manual (Page 99)

Serial Commands 93
Table 10-9. Setpoint Serial Commands
10.1.5 Normal Mode Commands
The normal mode print commands (see Table 10-10) transmit data to the serial port on demand in either setup or
normal mode.
SP.SENSE#n Digital output sense NORMAL, INVERT
SP.BRANCH#n Branch destination 0, 1-32
SP.RELNUM#n Relative setpoint number 1–32
SP.START#n Starting setpoint 1–32
SP.END#n Ending setpoint 1–32
SP.DISLOT#n Digital input slot NONE, SLOTx
SP.MASK#n Digital input mask number
SP.NSAMPLE#n Number of samples number
SP.TIME#n Trip time hhmm
SP.DURATION#n Trip duration hhmmss
SP.VUNDER#n Underrange value number
SP.VOVER#n Overrange value number
SP.DUNDER#n Underrange digital output BITx
SP.DACCEPT#n Accept digital output BITx
SP.DOVER#n Overrange digital output BITx
BATCHNG Batching mode OFF, AUTO, MANUAL
SP.ENABLE#n Setpoint enable ON, OFF
For setpoint commands ending with “#n”, n is the setpoint number.
Command Description Values
CONSNUM Set consecutive number 0–9 999 999
UID Set unit ID nnnnnnn
SD Set date MMDDYY, DDMMYY, YYMMDD, or YYDDMM. Enter six-digit
date using the year-month-day order specified for the
DATEFMT parameter, using only the last two digits of the year.
ST Set time hhmm (enter using 24-hour format)
CONTRAST Set display contrast 0–127
SX#p Start serial port streaming OK or ??
The port streaming parameter (EDP.STREAM#p) for the
streaming port must be set to LFT or INDUST before using
these commands.
An EX command sent while in setup mode does not take
effect until the indicator is returned to normal mode.
EX#p Stop serial port streaming
RS Reset system Soft reset. Used to reset the indicator without resetting the
configuration to the factory defaults.
SF#n Transmit single frame of stream Sends a single frame from scale n to the streaming port.
XA#1 Transmit accumulator value in displayed units nnnnnn UU
XAP#1 Transmit accumulator value in primary units
XAS#1 Transmit accumulator value in secondary units
XAT#1 Transmit accumulator value in tertiary units
Table 10-10. Normal Mode Serial Commands
Command Description Values