Rice Lake 720i Programmable Indicator/Controller - Installation Manual - Manual (Page 66)

60 720i Installation Manual
In Advance Mode the Weigh , Reports and Management
softkeys are enabled. Softkeys are described below.
Weigh Reports Management
12880
lb
G
Figure 7-3. 720i Display, showing Advance Mode Softkeys
Weigh Start the Weigh-In and Weigh-Out
P r o c e d u r e . S e e “ A d v a n c e M o d e
Weigh-In Procedure” on page 62.
Reports Select which report to print. There are
four sub menus under the
R e p o r t s
softkey: Summary , Daily , Detail , and
Code List .
Management Add and remove materials, customers,
and source IDs and names.
While in a submenu the TARE key can be pressed to go
back to the previous menu. If using the PS2 keyboard,
the
ESC key will take you to the previous menu.
On Weigh-In the AUX1FMT is printed.
On Weight-Out the AUX2FMT is printed.
When printing Shift/Day and Detail All/Pending
reports:
• AUX3FMT is the header
• AUX4FMT is each line for each transaction
• AUX5FMT is the footer/total lines
When printing Summary Reports:
• AUX6FMT is the header
• AUX7FMT is the header for Source Reports
• AUX8FMT is the header for Customer Reports
• AUX9FMT is the header for Material Reports
• AUX10FMT is each line for each transaction
for Source Reports
• AUX11FMT is each line for each transaction
for Customer Reports
• AUX12FMT is each line for each transaction
for Material Reports
• AUX13FMT is the sub total line
• AUX14FMT is the footer/total lines
When printing the Code list reports:
• AUX15FMT is the header
• AUX16FMT is printed for the Source
• AUX17FMT is printed for the Customers
• AUX18FMT is printed for the Materials
Print Format Commands
When the ADVANCE mode is selected the AUX
formats are changed to generic in/out formatting. This
can be changed using an EDP command. See “Advance
Mode EDP Commands” on page 97.
To see the configuration of the AUX format send:
AUXFMT.FMT#n (where n is the aux format number)
To change the format serially send:
AUXFMT.FMT#n=<><><>
Table 7-3. Print Format Commands
Command Description Characters
Truck ID 12
alpha numeric
Material ID 10
numeric only, no
decimals
Material Name /
Description
30
alpha numeric
Customer ID 10
numeric only, no
decimals
Customer Name /
Description
30
alpha numeric
Source ID 10
numeric only, no
decimals
Source Name /
Description
30
alpha numeric
Delivery / Challan
Number
15
alpha numeric
Delivery / Challan
Weight
Floating Point 9
Characters
Remarks /
Comments
30
alpha numeric
Vehicle ID /
Description 10
alpha numeric
Time / Date Out 18
Time / Date in 18
Report Type 24
Julian Date Number Floating Point with 5
Decimal Places
Ticket Consecutive
Number / Serial
Number
numeric