Rice Lake 720i Programmable Indicator/Controller - Installation Manual - Manual (Page 103)

Serial Commands 97
10.1.8 Advance Mode EDP Commands
See Table 10-16 for the EDP commands for the configuration of Advance Mode.
Table 10-16. Advance Mode EDP Commands
Command Value
DAY.END 000000 - 235959
DAY.START 000000 - 235959
SHIFT.1.END 000000 - 235959
SHIFT.1.START 000000 - 235959
SHIFT.2.END 000000 - 235959
SHIFT.2.START 000000 - 235959
SHIFT.3.END 000000 - 235959
SHIFT.3.START 000000 - 235959
PROMPT.COMMENTS ON/OFF
PROMPT.DELIVERY.NUM ON/OFF
PROMPT.DELIVERY.WGT ON/OFF
PROMPT.CUSTOMER ON/OFF
PROMPT.MATERIAL ON/OFF
PROMPT.REPRINT ON/OFF
PROMPT.SOURCE ON/OFF
PROMPT.VEHICLE ON/OFF
PROMPT.PRINT ON/PROMPT/OFF
SERIAL.NUMBER 0 - 9999999
Note
The 720i must see six digits of data for the time values in the first 8 parameters. If the 720i does not see at least
000000 it will respond with ??.