Dell PowerEdge FX2/FX2s - Manual (Page 13)

1
About this Guide
This guide describes the supported protocols and software features, and provides configuration
instructions and examples, for the Dell Networking FN I/O Aggregator running Dell Networking OS
version 9.6(0.0).
The I/O Aggregator is installed in a Dell PowerEdge FX2 server chassis. For information about how to
install and perform the initial switch configuration, refer to the Getting Started Guides on the Dell Support
website at
http://www.dell.com/support/manuals
Though this guide contains information about protocols, it is not intended to be a complete reference.
This guide is a reference for configuring protocols on Dell Networking systems. For complete information
about protocols, refer to other documentation, including IETF requests for comment (RFCs). The
instructions in this guide cite relevant RFCs, and Standards Compliance contains a complete list of the
supported RFCs and management information base files (MIBs).
NOTE: You can perform some of the configuration tasks described in this document by using either
the Dell command line or the chassis management controller (CMC) graphical interface. Tasks
supported by the CMC interface are shown with the CMC icon: CMC
Audience
This document is intended for system administrators who are responsible for configuring and maintaining
networks and assumes knowledge in Layer 2 and Layer 3 networking technologies.
Conventions
This guide uses the following conventions to describe command syntax.
Keyword Keywords are in Courier (a monospaced font) and must be entered in the CLI as
listed.
parameter Parameters are in italics and require a number or word to be entered in the CLI.
{X} Keywords and parameters within braces must be entered in the CLI.
[X] Keywords and parameters within brackets are optional.
x|y Keywords and parameters separated by a bar require you to choose one option.
x||y Keywords and parameters separated by a double bar allows you to choose any or
all of the options.
About this Guide 13