Dell PowerEdge FX2/FX2s - Manual (Page 127)

0 CRC, 0 overrun, 0 discarded
Output Statistics:
0 packets, 0 bytes, 0 underruns
0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
0 Multicasts, 0 Broadcasts, 0 Unicasts
0 throttles, 0 discarded, 0 collisions, 0 wreddrops
Rate info (interval 299 seconds):
Input 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Output 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Time since last interface status change: 00:11:36
Dell(conf-if-te-0/1)#
Sample Configuration
Dell# config terminal
Dell(conf)# no io-aggregator auto-lag enable
Dell(conf)# end
Dell# show io-aggregator auto-lag status
Auto LAG creation on server port(s) is disabled
Dell#
Dell# config terminal
Dell(config)# interface tengigabitethernet 0/1
Dell(config-if-te-0/1)# no auto-lag enable
Dell(config-if-te-0/1)# show config
!
interface TenGigabitEthernet 0/1
mtu 12000
portmode hybrid
switchport
no auto-lag enable
!
protocol lldp
advertise management-tlv management-address system-name
dcbx port-role auto-downstream
no shutdown
Dell#
Configuring the Minimum Number of Links to be Up for
Uplink LAGs to be Active
You can activate the LAG bundle for uplink interfaces or ports (the uplink port-channel is LAG 128) on the
I/O Aggregator only when a minimum number of member interfaces of the LAG bundle is up. For
example, based on your network deployment, you may want the uplink LAG bundle to be activated only if
a certain number of member interface links is also in the up state. If you enable this setting, the uplink
LAG bundle is brought up only when the specified minimum number of links are up and the LAG bundle
is moved to the down state when the number of active links in the LAG becomes less than the specified
number of interfaces. By default, the uplink LAG 128 interface is activated when at least one member
interface is up.
To configure the minimum number of member links that must be up for a LAG bundle to be fully up,
perform the following steps:
Specify the minimum number of member interfaces of the uplink LAG 128 bundle that must be up for
the LAG bundle to be brought up. The default minimum number of member links that must be active
for the uplink LAG to be active is 1. Enter the minimum-links number command in the Port
Channel Interface 128 Configuration mode to specify this value.
Link Aggregation 127