Dell PowerEdge FX2/FX2s - Manual (Page 111)

Without an interface specified, the command clears all
interface counters.
• (OPTIONAL) Enter the following interface keywords
and slot/port or number information:
• For a Port Channel interface, enter the keyword port-
channel followed by a number from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
numbers.
• For a VLAN, enter the keyword vlan followed by a
number from 1 to 4094.
When you enter this command, you must confirm that you want Dell Networking OS to clear the
interface counters for the interface (refer to the below clearing interface example).
Clearing an Interface:
Dell#clear counters tengig 0/1
Clear counters on TenGigabitEthernet 0/1 [confirm]
Dell#
Fibre Channel Interface
The FN 2210S functions as a converged enhanced Ethernet (CEE) switch that supports both LAN and
storage area network (SAN) traffic using the Fibre Channel protocol.
To access a SAN fabric, use a Fibre Channel (FC) module installed in the aggregator.
Configuring Fibre Channel Interfaces
To configure FC interfaces on the FN 2210S aggregator, follow these steps.
1. Enable Fibre Channel capability on the switch.
2. Configure Fibre Channel interfaces.
3. Verify the global Fibre Channel configuration on the switch and on individual interfaces.
Enabling Fibre Channel Capability
To enable Fibre Channel capability, follow this step.
Enable Fibre Channel capability.
CONFIGURATION mode
feature fc
Configuring Fibre Channel Interfaces
To configure a Fibre Channel interface, follow these steps.
Convert the interfaces 9 and 10 from FC to Ethernet mode.
CONFIGURATION mode
stack-unit unit number port-group 0 portmode ethernet
Interfaces 111