beautypg.com

Enabling lldp, Advertising tlvs – Dell PowerEdge FX2/FX2s User Manual

Page 219

background image

Dell(conf-if-te-0/3-lldp)#?

advertise Advertise TLVs

disable Disable LLDP protocol on this interface

end Exit from configuration mode

exit Exit from LLDP configuration mode

hello LLDP hello configuration

mode LLDP mode configuration (default = rx and tx)

multiplier LLDP multiplier configuration

no Negate a command or set its defaults

show Show LLDP configuration

Dell(conf-if-te-0/3-lldp)#

Enabling LLDP

LLDP is enabled by default. Enable and disable LLDP globally or per interface. If you enable LLDP globally,

all UP interfaces send periodic LLDPDUs.

To enable LLDP, use the following command.

1.

Enter Protocol LLDP mode.
CONFIGURATION or INTERFACE mode

protocol lldp

2. Enable LLDP.

PROTOCOL LLDP mode

no disable

Disabling and Undoing LLDP

To disable or undo LLDP, use the following command.

• Disable LLDP globally or for an interface.

disable

To undo an LLDP configuration, precede the relevant command with the keyword no.

Advertising TLVs

You can configure the system to advertise TLVs out of all interfaces or out of specific interfaces.

• If you configure the system globally, all interfaces send LLDPDUs with the specified TLVs.
• If you configure an interface, only the interface sends LLDPDUs with the specified TLVs.
• If you configure LLDP both globally and at interface level, the interface level configuration overrides

the global configuration.

To advertise TLVs, use the following commands.

1.

Enter LLDP mode.
CONFIGURATION or INTERFACE mode

protocol lldp

2. Advertise one or more TLVs.

PROTOCOL LLDP mode

PMUX Mode of the IO Aggregator

219