Dell PowerEdge FX2/FX2s - Manual (Page 197)

write memory
5. Reload the stack unit to activate the new Dell Networking OS version.
CONFIGURATION mode
reload
Example of Upgrading all Stacked Switches
The following example shows how to upgrade all switches in a stack, including the master switch.
Dell# upgrade system ftp: A:
Address or name of remote host []: 10.11.200.241
Source file name []: //FTOS-XL-8.3.17.0.bin
User name to login remote host: ftp
Password to login remote host:
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
Erasing IOM Primary Image, please wait
.!..............................................................................
...
...................................Writing......................................
...
................................................................................
...
................................................................................
...
31972272 bytes successfully copied
System image upgrade completed successfully.
Upgrade system image for all stack-units [yes/no]: yes
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!
!
Image upgraded to all
Dell# configure
Dell(conf)# boot system stack-unit all primary system: A:
Dell(conf)# end
Dell# write memory
Jan 3 14:01:48: %STKUNIT0-M:CP %FILEMGR-5-FILESAVED: Copied running-config to
startup-config
in flash by default
Synchronizing data to peer Stack-unit
!!!!
Dell# reload
Proceed with reload [confirm yes/no]: yes
Upgrading a Single Stack Unit
Upgrading a single stacked switch is necessary when the unit was disabled due to an incorrect Dell
Networking OS version. This procedure upgrades the image in the boot partition of the member unit
from the corresponding partition in the master unit.
To upgrade an individual stack unit with a new Dell Networking OS version, follow the below steps:
1. Download the Dell Networking OS image from the master's boot partition to the member unit, and
upgrade the relevant boot partition in the single stack-member unit.
EXEC Privilege mode
upgrade system stack-unit unit-number partition
2. Reboot the stack unit from the master switch to load the Dell Networking OS image from the same
partition.
Stacking 197