Dell PowerEdge FX2/FX2s - Manual (Page 285)

Rx VLAN Drops : 0
--- Ingress MAC counters---
Ingress FCSDrops : 0
Ingress MTUExceeds : 0
--- MMU Drops ---
HOL DROPS : 0
TxPurge CellErr : 0
Aged Drops : 0
--- Egress MAC counters---
Egress FCS Drops : 0
--- Egress FORWARD PROCESSOR Drops ---
IPv4 L3UC Aged & Drops : 0
TTL Threshold Drops : 0
INVALID VLAN CNTR Drops : 0
L2MC Drops : 0
PKT Drops of ANY Conditions : 0
Hg MacUnderflow : 0
TX Err PKT Counter : 0
Restoring the Factory Default Settings
Restoring factory defaults deletes the existing NVRAM settings, startup configuration and all configured
settings such as stacking or fanout.
To restore the factory default settings, use the restore factory-defaults stack-unit {0-5 |
all} {clear-all | nvram} command in EXEC Privilege mode.
CAUTION: There is no undo for this command.
Important Points to Remember
• When you restore all the units in a stack, all units in the stack are placed into stand-alone mode.
• When you restore a single unit in a stack, only that unit is placed in stand-alone mode. No other units
in the stack are affected.
• When you restore the units in stand-alone mode, the units remain in stand-alone mode after the
restoration.
• After the restore is complete, the units power cycle immediately.
The following example shows the using the restore factory-defaults command to restore the Factory
Default Settings.
Restoring the Factory Default Settings
Dell#restore factory-defaults stack-unit 0 nvram
***********************************************************************
* Warning - Restoring factory defaults will delete the existing *
* persistent settings (stacking, fanout, etc.) *
* After restoration the unit(s) will be powercycled immediately. *
* Proceed with caution ! *
*********************************************************************** Proceed
with factory
settings? Confirm [yes/no]:yes
-- Restore status -- Unit Nvram Config
------------------------
0 Success
Debugging and Diagnostics 285