Dell PowerEdge FX2/FX2s - Manual (Page 109)

speed auto interface-
config
mode
Supported Supported Supported Supported Error
messages not
thrown
wherever it
says not
supported
speed 1000 interface-
config
mode
Supported Supported Supported Supported
speed 10000 interface-
config
mode
Supported Supported Not Supported Not
supported
Error
messages not
thrown
wherever it
says not
supported
negotiation
auto
interface-
config
mode
Supported Not
supported(
Should
some
error
message
be
thrown?)
Not supported Not
supported
Error
messages not
thrown
wherever it
says not
supported
duplex half interface-
config
mode
Supported CLI not
available
CLI not available Invalid Input
error- CLI
not available
duplex full interface-
config
mode
Supported CLI not
available
CLI not available Invalid Input
error-CLI
not available
Viewing Interface Information
Displaying Non-Default Configurations.
The show [ip | running-config] interfaces configured command allows you to display only
interfaces that have non-default configurations are displayed.
The below example illustrates the possible show commands that have the available configured
keyword.
Dell#show interfaces configured
Dell#show interfaces tengigabitEthernet 0 configured
Dell#show ip interface configured
Dell#show ip interface tengigabitEthernet 1 configured
Dell#show ip interface brief configured
Dell#show running-config interfaces configured
Dell#show running-config interface tengigabitEthernet 1 configured
In EXEC mode, show interfaces switchport command displays only interfaces in Layer 2 mode and
their relevant configuration information. The show interfaces switchport command displays the
Interfaces 109