Dell PowerEdge FX2/FX2s - Manual (Page 110)

interface, whether the interface supports IEEE 802.1Q tagging or not, and the VLANs to which the
interface belongs.
show interfaces switchport Command Example:
Dell#show interfaces switchport
Codes: U - Untagged, T - Tagged
x - Dot1x untagged, X - Dot1x tagged
G - GVRP tagged, M - Trunk, H - VSN tagged
i - Internal untagged, I - Internal tagged, v - VLT untagged, V - VLT
tagged
Name: TenGigabitEthernet 0/1
802.1QTagged: False
Vlan membership:
Q Vlans
U 1
Name: TenGigabitEthernet 0/2
802.1QTagged: False
Vlan membership:
Q Vlans
U 1
Name: TenGigabitEthernet 0/3
802.1QTagged: False
Vlan membership:
Q Vlans
U 1
Name: TenGigabitEthernet 0/4
802.1QTagged: False
Vlan membership:
Q Vlans
U 1
--More--
Clearing Interface Counters
The counters in the show interfaces command are reset by the clear counters command. This
command does not clear the counters captured by any SNMP program.
To clear the counters, use the following command in EXEC Privilege mode:
Command Syntax Command Mode Purpose
clear counters [interface] EXEC Privilege Clear the counters used in the show interface commands
for all VLANs, and physical interfaces or selected ones.
110 Interfaces