Dell PowerEdge FX2/FX2s - Manual (Page 57)

Reason Description
LLDP Rx/Tx is
disabled LLDP is disabled (Admin Mode set to rx or tx only) globally or on the interface.
Waiting for Peer Waiting for peer or detected peer connection has aged out.
Multiple Peer
Detected Multiple peer connections detected on the interface.
Version Conflict DCBx version on peer version is different than the local or globally configured
DCBx version.
Config-source
Down Although DCBx parameters match in auto-upstream or auto-downstream port, the
configuration source (elected dynamically or CLI-configured) is down.
Unrecognized TLV
received Invalid TLV length TLV has been received. In the case of an invalid PFC or ETS TLV,
the error displays in the show interfaces pfc | ets output. The show
interfaces dcbx output displays PFC or ETS as down.
Admin Mode OFF
(Local) Local Admin Mode is disabled.
Admin Mode OFF
(Remote) Remote Admin Mode is disabled.
Waiting for ACK
from Peer For a legacy DCBx version, a peer has not acknowledged the reception of a sent
packet. This reason displays only when a remote peer is willing to receive a DCB
configuration.
Error Bit set For a legacy DCBx version, a peer has sent packets with an error bit set. This reason
displays only when a remote peer is willing to receive a DCB configuration.
Enabled with ETS
Mismatch (show
interfaces
dcbx output) DCBx is enabled but an ETS validation failure error has occurred.
PFC is down (show
interfaces pfc
output) One of the following PFC-specific errors has occurred:
• No MBC support.
• Configured PFC priorities exceed maximum PFC capability limit.
• New dot1p-to-queue mapping violates the allowed system limit for PFC Enable
status per priority
ETS is down (show
interfaces ets
output) One of the following ETS-specific errors occurred in ETS validation:
• Unsupported PGID
• A priority group exceeds the maximum number of supported priorities.
• COSQ is mapped to more than one priority group.
• COSQ is mapped to more than one priority group. - Invalid or unsupported
transmission selection algorithm (TSA).
• Bandwidth is configured for an unconfigured priority group.
• Total ETS bandwidth mapped in priority groups is not equal to 100%.
• Priorities mapped to a queue use different TSAs.
Data Center Bridging (DCB) 57