Dell PowerEdge FX2/FX2s - Manual (Page 117)

You can send iSCSI TLVs either globally or on a specified interface. The interface configuration takes
priority over global configuration.
The default is Enabled.
10. (Optional) Configures the advertised priority bitmap in iSCSI application TLVs.
LLDP CONFIGURATION mode
[no] iscsi priority-bits.
The default is 4 (0x10 in the bitmap).
11. (Optional) Enter interface configuration mode to configure the auto-detection of Dell Compellent
disk arrays.
CONFIGURATION mode
interface port-type slot/port
12. (Optional) Configures the auto-detection of Compellent arrays on a port.
INTERFACE mode
[no] iscsi profile-compellent.
The default is: Compellent disk arrays are not detected.
NOTE: All these configurations are available only in PMUX mode.
Displaying iSCSI Optimization Information
To display information on iSCSI optimization, use the show commands detailed in the below table:
Table 7. Displaying iSCSI Optimization Information
Command Output
show iscsi Displays the currently configured iSCSI settings.
show iscsi sessions Displays information on active iSCSI sessions on the
switch that have been established since the last reload.
show iscsi sessions detailed [session isid] Displays detailed information on active iSCSI sessions
on the switch. To display detailed information on
specified iSCSi session, enter the session’s iSCSi ID.
show run iscsi Displays all globally-configured non-default iSCSI
settings in the current Dell Networking OS session.
show iscsi Command Example
Dell# show iscsi
iSCSI is enabled
iSCSI session monitoring is enabled
iSCSI COS : dot1p is 4 no-remark
Session aging time: 10
Maximum number of connections is 256
------------------------------------------------
iSCSI Targets and TCP Ports:
iSCSI Optimization 117